Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 295

Table 4-69
CP SCC Loopback Test Failed on Channel x message
2 8 9
CP SCC Loopback Test Failed on
Channel x
Display: Maintenance terminal
2 9 0
Alarm Level:
Processor switch
2 9 1
Customer-Selected Alarm Level
2 9 2
Other Alarm Indications
2 9 3
System Recovery Action
2 9 4
Craftsperson Activity:
BMC II BISYNC Operation, Administration, and Maintenance Guide BMCB001 and up
Section 060-INDP-410 Command and Message Guide 4-135
Where: x = channel identifier (A or B)
Cause: 56K Interface SCC loopback test failed for the
designated channel.
Reason Code = N/A
Corresponds to ERRMAP entry: CP FAULT
System Default:
Type:MajorLevel:1
Type:Level:
Default:
Status Panel: MajorAudible:Major
Customer-Selected
Status Panel:Audible:
Processor switch.
Refer to the 56K Interface PCA Replacement
Procedure in the Maintenance Procedures Guide
section.