Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 567

Table 6-11
DRAM Expansion PCA (A3 and B3) options - part number: NT6M64AA
Device type Position/
(number) setting
Jumper A
Out
In
Out
In
Jumper B
In
In
Out
Out
Jumper C
Out
Out
In
In
Strap None Used
DIP Switch None Used
Rotary Switch None Used
Switch None Used
Note: There are no customer-definable options on this PCA. Information is shown for reference
only. Use this data for verification during initial BMC system installation and/or PCA replacement
to make sure the replacement PCA is set up the same as the PCA being replaced.
BMC II BISYNC Operation, Administration, and Maintenance Guide BMCB001 and up
Section 060-INDP-610 Maintenance Procedures Guide 6-129
Function
Card 1
Card 2
Card 1 (64K only)
Card 2 (64K only)
Card 1
Card 2
Card 1 (64K only)
Card 2 (64K only)
Card 1
Card 2
Card 1 (64K only)
Card 2 (64K only)
Setting
Factory On-site
Must be the
Out same as the
(card 1 in A3) factory setting.
Must be the
In same as the
(card 1 in A3) factory setting.
Must be the
Out same as the
(card 1 in A3) factory setting.