4-100 Section 060-INDP-410 Command and Message Guide
Table 4-30
BAD xxxIDX FILE message
5 7
Customer-Selected Alarm Level
5 8
Other Alarm Indications
5 9
System Recovery Action
6 0
Craftsperson Activity:
Table 4-31
BLOCK LENGTH ERROR DETECTED message
6 1
BLOCK LENGTH ERROR
DETECTED
Display: Log message
6 2
Alarm Level:
No processor switch
6 3
Customer-Selected Alarm Level
6 4
Other Alarm Indications
6 5
System Recovery Action
6 6
Craftsperson Activity:
297-6201-502 Standard 01.02 September 2000
Type:Level:
Default:
Status Panel:MinorAudible:Minor
Customer-Selected
Status Panel:Audible:
None
Refer to the Index Corruption Recovery Procedure in
the Maintenance Procedures Guide section.
Cause: output when a block length error is detected by
the TEC/DSI PCA. This message also indicates that
the number of invalid blocks received exceeds the
threshold limit for the invalid blocks set using the
VALPARM BLOCKS command.
Reason Code = N/A
Corresponds to ERRMAP entry: EXCESS INV BLKS
System Default:
Type:MajorLevel:0
Type:Level:
Default:
Status Panel:MajorAudible:Major
Customer-Selected
Status Panel:Audible:
None
Refer to the TEC/DSI PCA Diagnostic Procedure in the
Maintenance Procedures Guide section.