Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 313

Table 7-87
DISK QUEUE ERROR message
7 9 (log message)
DISK QUEUE ERROR
Display: Log message
8 0
Alarm Level:
8 1
Customer-Selected Alarm Level
8 2
Other Alarm Indications
8 3
System Recovery Action
8 4
Craftsperson Activity:
BMC II BISYNC Operation, Administration, and Maintenance Guide BMCB001 and up
Section 060-INDP-410 Command and Message Guide 4-153
Cause: output if no free command nodes are available.
Reason Code = 29
Corresponds to ERRMAP entry: DSK CARD HW ERR
System Default:
Type:MajorLevel:2
Type:Level:
Default:
Status Panel:MajorAudible:Major
Customer-Selected
Status Panel:Audible:
Retry
If this message is seen repeatedly from the same
processor, replace the SCSI Interface PCA using the
Miscellaneous PCA Replacement Procedure in the
Maintenance Procedures Guide section.