Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 312

4-152 Section 060-INDP-410 Command and Message Guide
Table 7-86
DISK NOT READY SIDE x message
7 3 (log message)
DISK NOT READY
SIDE x
Display: Log message
7 4
Alarm Level:
Disk mode non-redundant
7 5
Customer-Selected Alarm Level
7 6
Other Alarm Indications
7 7
System Recovery Action
7 8
Craftsperson Activity:
297-6201-502 Standard 01.02 September 2000
Where: x = disk drive (A or B)
Cause: output when the system SCSI Interface is going
through initialization and the indicated drive unit does
not return READY status after 30 seconds.
Reason Code = 30
Corresponds to ERRMAP entry: DISK MODE ALARM
System Default:
Type:MajorLevel:0
Type:Level:
Default:
Status Panel:MajorAudible:Major
Customer-Selected
Status Panel:Audible:
Disk mode is changed to ONLY if disk is not being
formatted.
Refer to the Disk Drive Diagnostic Procedure in the
Maintenance Procedures Guide section.