Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 257

Table 4-26
BAD INTERFACE
3 1
BAD INTERFACE
Display: Maintenance terminal
3 2
Alarm Level:
N/A
3 3
Customer-Selected Alarm Level
3 4
Other Alarm Indications
3 5
System Recovery Action
3 6
Craftsperson Activity:
Table 4-27
BAD LINE CONTROL SELECTION message
3 7 BAD LINE CONTROL SELECTION,
VALID SELECTIONS - FD or HD
Display: Log message
3 8
Alarm Level:
N/A
3 9
Customer-Selected Alarm Level
BMC II BISYNC Operation, Administration, and Maintenance Guide BMCB001 and up
Section 060-INDP-410 Command and Message Guide 4-97
Cause: output when an incorrect value was input for the
CP INTERFACE command.
Reason Code = N/A
Corresponds to ERRMAP entry: N/A
System Default:
Type:N/ALevel:N/A
Type:Level:
Default:
Status Panel:Audible:
Customer-Selected
Status Panel:Audible:
None, faulty keyboard entry.
Enter the correct interface type. Refer to section on the
CP INTERFACE command in this document.
Cause: output when a line control parameter other than
one of the two listed in the message is used with the CP
CONTROL command.
Reason Code = N/A
Corresponds to ERRMAP entry: N/A
System Default:
Type:MajorLevel:3
Type:Level: