Table of Contents
Advertisement
Serial port
iv. (Optional) Enable mDNS. mDNS is a protocol that resolves host names in small
networks that do not have a DNS server.
(config serial USB_port)> service ssh mdns enable true
(config serial USB_port)>
8. Save the configuration and apply the change:
(config serial USB_port)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show serial status and statistics
To show the status and statistics for the serial port:
WebUI
1. Log into the Connect IT 16/48 WebUI as a user with Admin access.
2. On the main menu, click Status
3. Under Connections, click Serial. The Serial Status page displays. See
information about the features in this page.
Command line
1. Log into the Connect IT 16/48 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the
show serial
> show serial
Digi Connect IT® 16/48 User Guide
--------------------------------------------------
-----------------------------
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config serial USB_port)>
Repeat this step to list additional firewall zones.
command:
Show serial status and statistics
Serial Status page
for
180
Advertisement
Table of Contents
