9-2 Description of the Digital Keypad KPC-CC01
KPC-CC01
Keypad Functions
Key
Start Key
This button is valid only when the keypad is the source of the command.
This button causes the motor drive to run according to its settings. See "LED Function
Pressing the RUN button repeatedly is allowed while the motor drive is stopping.
Stop Key
The STOP key has the highest priority in command.
Press the STOP key to stop the drive under any conditions.
Press the RESET key to reset the drive when faults occur. If the RESET key does not
Operation Direction Key
The FWD/REV key controls the operation direction but does NOT activate the drive.
The drive operates in the direction as shown by the LED.
ENTER Key
Press the ENTER key to go to the next menu level. If you are at the last level, then press
ENTER to execute the command.
ESC Key
Press the ESC key to return to the previous page, or return to the last category in the
sub-menu.
MENU Key
Press the MENU key to return to the main menu.
Menu items:
1. Parameter Setup
2. Copy Parameter
3. Keypad Locked
4. PLC Function
IED-S does not support menu item 4 and 5 (PLC functions) and menu item 7 (Quick Start).
Direction: Left/Right/Up/Down cursor keys
In the numeric value setting mode, press Left and Right to move the cursor; press Up
In the menu/text selection mode, use the Up and Down cursor keys to select an item.
Descriptions" for LED status.
respond, go to MENU "Fault Records" to check the most recent fault.
FWD: forward, REV: reverse.
5. Copy PLC
6. Fault Record
7. Quick Start
8. Display Setup
and Down to change the selected value.
Communication Interface
RJ45 (socket), RS-485 interface
Installation method
Place the keypad flat on the surface of the control
box. The front cover is waterproof.
Use a model MKC-KPPK for wall mounting or
embedded mounting. Its protection level is IP66.
The maximum RJ45 extension cable is 5 m (16 ft).
This keypad can also be used on Delta's motor
drives C2000, CH2000, CP2000 and IED-S.
Description
9. Time Setup
10. Language Setup
11. Start-up
12. Main Page
9-5
Chapter 9 Digital Keypad | IED-S
13. PLC Link