10-2 Motor Parameter
If you do not do the wiring or do not wire according to the manual instructions, some fault codes
may occur, but it does not affect the tuning process.
10-2-1 Pr.13-01 Control Mode
3: FOC vector control + Encoder (FOCPG) (IM; Induction Motor)
8: FOC Permanent Motor control (FOCPM) (PM; Permanent Motor)
10-2-2 Pr.13-03 Elevator Rated Frequency
Sets this value according to the motor nameplate. In general, set this value equal to motor's
rated frequency.
10-2-3 Pr.13-04 Motor Rated Frequency
Sets this value according to the motor nameplate. If the motor is 60 Hz, set this parameter to
60. If the motor is 50 Hz, set it to 50.
Press
Press
Press
Press
Press
Press
10-3
Chapter 10 Auto-tuning Process | IED-S