Delta IED-S Series User Manual page 246

13 Drive Parameters
Pr. Parameter Name
13-00 Drive Software Version
13-01 Control Mode
13-02 Drive Output Direction
13-03 Elevator Rated Frequency
13-04 Motor Rated Frequency
13-05 Motor Rated Voltage
13-06 Motor Rated Current
13-07 Motor Rated Power
13-08 Motor Rated Speed
13-09 Number of Motor Poles
13-10 IM No-load Current
13-11 IM/PM Rs
13-12 IM Rr
13-13 IM Lm
13-14 IM Lx/PM Lq
PM Back Electromotive
13-15
Force
PM Magnetic Pole Offset
13-16
Angle
13-17 System Control
13-18 Current Floor of the Drive
13-19 Pulse Adjustment Condition
Maximum Elevator Speed
13-20
Percentage
13-21 Motor Auto-tuning
13-22 Selection of Encoder
13-23 Encoder Pulse
Chapter 11 Summary of Parameter Settings | IED-S
Setting Range
Read only
0–8
3: FOC vector control + Encoder (FOCPG)
8: FOC Permanent Motor control (FOCPM)
0–1
0: The same as the setting direction
1: Opposite to the setting direction
0.00–400.00 Hz
0.00–400.00 Hz
0.0–510.0 V
0.10–650.00 Amps
0.10–650.00 kW
0–65535 rpm
0–96
0.00–655.35
0.000–65.535 Ω
0.000–65.535 Ω
0.0–6553.5 mH
0.0–6553.5 mH
0.0–6553.5 Vrms
0.0–360.0°
0000h–FFFFh
Bit 0=0: No function
Bit 0=1: ARS auto-tuning; PDFF enabled; speed
bandwidth control enabled
Bit 7=0: No function
Bit 7=1: Zero speed position control is enabled
Bit 9=0: Dynamic PG origin auto-tuning with load
(supported by PGHSD-x)
Bit 9=1: Static PG origin auto-tuning with load by
enabling PGHSD-x
1–64
0–100
30–100
0–3
0: No function
1: Only for an unloaded motor; auto-measures the
magnetic pole offset angle (PM)
2: Executes motor auto-ting (IM / PM)
3: Auto-measures the magnetic pole offset angle (PM)
0–6
0: Disabled
1: ABZ
2: ABZ + Hall (UVW type)
3: SIN/COS + Sinusoidal (ERN1185, ERN1387)
4: SIN/COS + Endat (ECN1313, ECN413)
5: SIN/COS
6: SIN/COS + Hiperface (SRS50/60)
1–25000
11-45
Default
#.##
0
0
60.00
60.00
440.0
2.00
2.00
0
0
0.00
0.000
0.000
0.0
0.0
0.0
360.0
0281h
1
100
50
0
0
2048