Drive Parameters - Delta IED-S Series User Manual

Chapter 12 Descriptions of Parameter Settings

13 Drive Parameters

Drive Software Version
Settings Read only
 Drive's released firmware version
Control Mode
Settings 0–8
 Mode selection:
Control
Settings
Mode
3 FOCPG
8 FOCPM
 Determines the control mode of the drive.
3: To increase torque and the accuracy of the speed control (1:1000).
8: To increase torque and the accuracy of the speed control (1:1000).
 Note: Pr.13-04–Pr.13-09 are automatically cleared if you change the control mode.
Drive Output Direction
Settings 0–1
 Use this parameter when elevator running direction is opposite to the command direction.
 If the elevator running direction is opposite to the setting direction, you must set Pr.13-02 and
Pr.03-22 (Reverse Pulse Logic) simultaneously.
Elevator Rated Frequency
Settings 0.00–400.00 Hz
 Sets this value according to the motor nameplate. In general, set this value equal to motor's rated
frequency.
 Sets the drive's maximum operating frequency range.
The formula is: Pr.13-03 = (Pr.13-09 Number of Motor Poles × RPM when elevator runs with
rated speed) ÷ 120
Motor Rated Frequency
Settings 0.00–400.00 Hz
 Sets this value according to the motor nameplate. If the motor is 60 Hz, set this parameter to 60.
If the motor is 50 Hz, set it to 50.
Motor Rated Voltage
3: FOC vector control + Encoder (FOCPG)
8: FOC Permanent Motor control (FOCPM)
Applicable Speed Energy-
Motor Type Feedback saving
✓
IM High
✓
PM High
0: The same as the setting direction
1: Opposite to the setting direction
Chapter 12 Descriptions of Parameter Settings | IED-S
: You can set this parameter during operation.
Speed
Tuning Ride
Control
Difficulty Comfort
Range
High Good 1:1000
High Good 1:1000
12-13-1
Default: #.##
Default: 0
Motor
Basic Speed
Parameter
Control Control
Tuning
Vector Frequency
✓
control Control
Vector Frequency
✓
control control
Default: 0
Default: 60.00
Default: 60.00
Default: 440.0