Floor Position 2 - Delta IED-S Series User Manual

Chapter 12 Descriptions of Parameter Settings

10 Floor Position 2

 Parameter Group 10 sets the hoistway parameter values. You can use hoistway auto-tuning to
obtain the hoistway parameter values.
 Pr.10-52 to Pr.10-79 are for position adjustments (51S–64S). Use them to fine-tune each floor
position after being obtained from floor turning for an optimal elevator height position.
 Each floor uses two sets of parameter; one is the high position (meter/m), and the other is the low
position (millimeter/mm) to indicate the accurate floor position.
1. Pr.10-36 to Pr.10-51 are the accurate positions for hoistway switch, including the upper/lower
limit switch and forced deceleration sensors.
2. A maximum of four forced deceleration sensors are provided for IED-S. Among them, the
nearest to the top and bottom floors is the first one forced deceleration sensor; the furthest is
the fourth one; between them are the second one and third one.
3. If the forced deceleration sensor is triggered during the elevator's running, IED-S detects the
elevator's running speed and checks if the speed and position are abnormal. If abnormal, the
elevator will be forced to decelerate to prevent overshoot.
4. For details on the installation position of the forced deceleration sensors, see Section 10-6-3
<Installation Position of Upward and Downward Forced Deceleration Sensor>.
47S High Position
Settings 0–65535 m
47S Low Position
Settings 0.0–6553.5 mm
48S High Position
Settings 0–65535 m
48S Low Position
Settings 0.0–6553.5 mm
49S High Position
Settings 0–65535 m
49S Low Position
Settings 0.0–6553.5 mm
50S High Position
Settings 0–65535 m
50S Low Position
Settings 0.0–6553.5 mm
Chapter 12 Descriptions of Parameter Settings | IED-S
: You can set this parameter during operation.
12-10-1
Default: Read only
Default: Read only
Default: Read only
Default: Read only
Default: Read only
Default: Read only
Default: Read only
Default: Read only