Delta IED-S Series User Manual page 315

Chapter 12 Descriptions of Parameter Settings | IED-S
Setting
Value
button)
DOBH2B (Rear door open auxiliary
175
extended button)
201 PK (Peak running at random floor)
202 REPK (Remove peak running)
PASSWORD (Execute password car
203
call while LED lights)
PASSSET (Execute password setting
204
while LED lights)
Y1
Y2
Y3
Y4
Y5
Y6
Y7
Y8
Settings
Description of Function Settings
Normally open (N.O.) (contact A). ON: The contact is closed; OFF: The contact is open.
Normally closed (N.C.) (contact B). OFF: The contact is closed; ON: The contact is open.
Setting
Value
1 SW (Operation contactor)
2 BY1 (Brake-1 contactor)
3 BY2 (Brake-2 contactor)
4 BY3 (Brake-3 contactor)
BY4 (Brake contactor for full
5
voltage)
FX (Motor Phase Short Circuit
6
Contactor (PM))
7 BU (Contactor of brake unit)
8 MFN (Main fan)
9 YUPS (UPS stops output)
10 PRST (Earthquake reset)
11 NOR (Normal running)
MI Function
See the setting value in Description of Function Settings for details
MO Function
LED indicator is ON.
Rear door open auxiliary extended button is pressed
when LED indicator is ON.
Executes floor setting for peak running at random
floor when LED indicator is ON.
Cancels peak running when LED indicator is ON.
Executes password car call when LED indicator is
ON.
Executes password setting when LED indicator is
ON.
Controls the operation
Controls brake-1 contactor
Controls brake-2 contactor
Controls brake-3 contactor
Controls brake for full voltage
Controls MPSCC
The contactor that controls between brake unit and
discharge resistance. Also can be used as a contactor
that controls among motor, control panel, and discharge
resistance fan.
Controls among motor, control panel, and discharge
resistance fan.
Make UPS stop supplying power after UPS emergent
safety landing is finished.
Resets minor earthquake (P-wave) signal of earthquake
detector
Elevator runs in normal mode
12-06-8
Description
Default: 1
Default: 2
Default: 5
Default: 15
Default: 7
Default: 13
Default: 0
Default: 0
Description