Delta IED-S Series User Manual page 265

Integrated elevator drive
Table of Contents

Advertisement

Chapter 12 Descriptions of Parameter Settings | IED-S
134: Door zone signal ON error
135: Load exceeds 150%
136: FX (MPSCC) feedback ON error
137: Safety hatch high voltage error
138: Upward operation at stop exceeds
139: Downward operation at stop exceeds
140: Motor temperature error
141: Exceeds the constant running time
142: Governor error
143: Exceeds specified floor running time
144: Mismatched current floor
145: The number of times for drive error occurred has reached five
146: Drive communication time-out
147: Communication between IED-S and cartop board
148: BY1NC ON detection error
149: BY2NC ON detection error
150: Unqualified braking force test
151: Operation contactor sticking
152: Runs with door open
153: Safety hatch low voltage error
154: Runs in an opposite direction
155: BK3 is not active
156: BY3NC ON detection error
157: Traveling cable insertion car communication
158: MPSCC feedback OFF error
159: SX2 door unlock OFF detection error
160: STO relay sticking
161: STO OFF error
162: BK1 is not reset
163: BK2 is not reset
164: BK3 is not reset
165: BK1 contactor sticking
166: BK2 contactor sticking
167: BK3 contactor sticking
168: Upward operation exceeds
169: Downward operation exceeds
170: SY door unlock output sticking
172 :Upward limit action
173: Upward forced deceleration 1
174: Upward forced deceleration 2
175: Upward forced deceleration 3
176: Downward limit action
177: Downward forced deceleration 1
178: Downward forced deceleration 2
179: Downward forced deceleration 3
180: Not at the bottom floor as displayed
181: Not at the top floor as displayed
182: At the bottom floor but not as displayed
183: At the top floor but not as displayed
184: Speed is slower than 0.01 m/s
185: All inputs are OFF
186: Upward forced deceleration 4
187: Downward forced deceleration 4
188: Starting signal abnormally disappears
189: Upward target error in direct docking
190: Downward target error in direct docking
191: INV DRV DIR error
192: INV VFD DIR error
193: VFD DRV DIR error
12-01-2

Advertisement

Table of Contents
loading

Table of Contents