Table of Contents
Advertisement
Chapter 11 Summary of Parameter Settings
This chapter provides a summary of parameter settings including the ranges and defaults that help
you set the parameters. You can set, change, and reset the parameters with the digital keypad.
NOTE
1）
: Parameters that you can set during operation.
2） For more details on parameters, see Chapter 12 Descriptions of Parameter Settings.
00 System Monitoring
Pr.
Parameter Name
00-00
Present Fault Code
00-01
Speed Command
00-02
HVX1–HVX5 Status
00-03
X1–X16 Status
00-04
X17–X25 Status
00-05
Y1–Y8 Status
00-07
Elevator Speed Detection
00-08
Elevator Mode 0
Chapter 11 Summary of Parameter Settings | IED-S
Setting Range
0–65535
0–65535
5: Emergency stop, using Pr.04-29 (Inspection
Deceleration)
6: Braking force test
7: EPS runs
8: Braking force test ended
10: Inspection stops, using Pr.04-29 (Inspection
Deceleration)
15: Executes DC braking, stopping at zero speed
control
20: Runs multi-step speed using Pr.04-11
(Re-leveling Deceleration) deceleration to zero
speed
25: Pr.04-00 (Speed at Emergency)
30: Pr.04-01 (Inspection Speed)
40: Pr.04-05 (Leveling Speed)
45: Pr.04-04 (Non-leveling Speed)
55: Pr.04-03 (Hoistway Auto-tuning Speed)
60: Pr.04-02 (Speed at Returning to Two Ends of the
Hoistway)
65: Speed at direct docking
66: Direct docking enables zero speed
70: Does not output
75: Drive Pr.01-22 (JOG Frequency) setting value is
being modified
76: Auto-tunes
77: No speed command
80: No speed command exceeds 0.1 second or STO
is not ON
0000h–FFFFh
0000h–FFFFh
0000h–FFFFh
0000h–FFFFh
0.000–65.535
0000h–FFFFh
bit 0: Manual (EIS Emergency Operation)
bit 1: Manual (INSCP inspection)
bit 2: Manual (MATPT inspection)
bit 3: Manual (TCI inspection)
bit 4: Manual (INSIC inspection)
bit 5: Manual (DBP Doorlock bypass)
bit 6: Auto-resets at flood
bit 7: Does not auto-rest at flood
bit 8: When using emergency power supply (UPS),
11-1
Default
Read only
Read only
Read only
Read only
Read only
Read only
Read only
Read only
Advertisement
Table of Contents
