Delta IED-S Series User Manual page 214

02 System Configuration
Pr. Parameter Name
02-00 Car Call Test

02-01 Upward Hall Call Test

02-02 Downward Hall Call Test

02-03 Auto-test Method
02-04 Number of Times for Auto-test
02-05 Interval for Auto-test
Forced Door Opening/Closing
02-06
Test
02-07 Car/Hall Call Disabled
02-08 Parameter Reset
02-10 Doorlock Bypass Buzzer Off
02-25 Clock-Year

02-26 Clock-Month

Chapter 11 Summary of Parameter Settings | IED-S
Setting Range
0–164
0–164
0–164
0–3
0: No test
1: Test for the top and bottom floor
2: Test for each floor
3: Random call
0–65535
65535: Continues to random test
0–3600
0–4
0: Normal mode
1: Front door is forced to open
2: Rear door is forced to open
3: Front and rear door are forced to open
4: Front and rear door are forced to close
0–5
0: Normal
1: Hall call is disabled
2: Hall call is disabled, and car call cannot register
any new call. Pr.02-00 (Car Call Test) is valid.
3: Car call and hall call are both disabled
4: Car call and hall call are both disabled, and door
opening is also disabled.
5: Hall call is disabled, car call cannot register any
new call, and the door opening is disabled. Pr.02-00
(Car Call Test) is valid.
0–65535
101: Single-door + Normal + First one forced
deceleration
102: Single -door + Normal + Second one forced
deceleration
111: Single -door + Disability + First one forced
deceleration
112: Single -door + Disability + Second one forced
deceleration
201: Two-door + Normal + First one forced
deceleration
202: Two-door + Normal + Second one forced
deceleration
211: Two-door + Disability + First one forced
deceleration
212: Two-door + Disability + Second one forced
deceleration
300: Specifically defined single IED-S 1
301: Specifically defined control cabinet 1
0–1
0: Disabled
1: If the elevator runs with doorlock bypass device,
the multi-function output terminal setting 105 BPSL
(Doorlock bypass lighting alarm) and 104 BZ (buzzer)
do not output, and 106 UDCL (Car bottom Light)
remains ON without flashing. Pr.02-10 is
automatically set to 0 after power-on again.
0–2099
0–12
11-13
Default
1
1
1
0
0
30
0
0
0
0
0
0