Table of Contents
Advertisement
Chapter 14 Fault Codes | IED-S
Code#
KPC-CC01 Display
F156
Action
Related Parameters
Reset Method
Code#
KPC-CC01 Display
F157
Action
Related Parameters
Reset Method
Code#
KPC-CC01 Display
F158
Action
Related Parameters
Reset Method
Code#
KPC-CC01 Display
F159
Action
Related Parameters
Reset Method
Fault Name
Fault occurs when BY3NC (Brake-3 contactor
BY3NC ON detection
detection) signal is not OFF after brake contactor
error
activates (ON)
Action and Reset
Stops urgently
MI=29 BY3NC (N.C. contact of Brake-3 contactor)
Press the upward or downward operation button for the manual mode, press the
RESET key on the digital keypad, press the external reset device, or power-on
again (choose either)
Fault Name
Fault occurs when a communication error occurs
Traveling cable
between IED-S and cartop board for elevator mounted
insertion car
with TCIN traveling cable and with TCIN signal ON
communication
while elevator is in stop status
Action and Reset
Stops urgently
MI=25 TCIN (Traveling cable insertion)
Resets automatically once the fault is cleared
Fault Name
MPSCC feedback OFF
Fault occurs when there is MPSCC (Motor Phase Short
error
Circuit Contactor) signal feedback error
Action and Reset
Stops urgently
MI=63 FXNO (N.O. contact of MPSCC (Motor Phase Short Circuit Contactor))
When the elevator is in stop status, press the RESET key on the digital keypad,
press the external reset device, or power-on again (choose either)
Fault Name
SX2 door unlock OFF
Fault occurs when SX2 door unlock detection signal is
detection error
not ON after SY door unlock output activates (ON)
Action and Reset
The function of "re-leveling after door open" and "door pre-open at stop" are
cancelled
MI=62 SX2 (Door unlock output feedback)
Press the RESET key on the digital keypad, press the external reset device, or
power-on again (choose either)
14-12
Description
Description
Description
Description
Advertisement
Table of Contents
