Table of Contents
Advertisement
4. Line driver output encoder application: Each set of input current is 5–15 mA. If input voltage uses 5V or
12V external power, see the PG wiring Figure 11 below.
EMED-PGABD-x
EMED-PGABD-x
NOTE
Verify that the SW1 is set to the correct output voltage before powering ON.
Keep the motor drive wiring away from any high voltage lines to avoid interference.
When using push-pull output and voltage output, short-circuit A , B , Z to 0V.
When using open collector output, short-circuit A, B, Z to VP.
Line Driver Encoder
Figure 10
Line Driver Encoder
Figure 11
7-7
Chapter 7 Option Cards | IED-S
Advertisement
Table of Contents
