Table of Contents
Advertisement
Chapter 12 Descriptions of Parameter Settings | IED-S
X20
X21
X22
X23
X24
X25
HVX1
HVX2
HVX3
HVX4
HVX5
Settings See the setting value in the Description of Function Settings for details
You must set X1=1 (DZU; Upper Leveling Sensor) and X3=2 (DZD; Lower Leveling Sensor). For
other MIs, you can set them to different functions according to your needs.
Setting the setting value to thousands digit changes the contact from N.O. to N.C. or vice versa.
For example, if you set DZU (Upper Leveling Sensor) to 1, the contact is N.O. (Normally Open); if
you set DZU (Upper Leveling Sensor) to 1001, the contact becomes N.C. (Normally Closed).
The function of MI contacts is unique, that is, you cannot enter the same value into different
parameters simultaneously (even across Parameter Group 06 and 07).
Description of Function Settings
Normally open (N.O.) (contact A). ON: The contact is closed; OFF: The contact is open.
Normally closed (N.C.) (contact B). OFF: The contact is closed; ON: The contact is open.
Setting
Value
1
DZU (Upper leveling sensor)
2
DZD (Lower leveling sensor)
3
FL1 (Upper door zone sensor)
4
FL2 (Lower door zone sensor)
5
FL1NC (Contact B of the relay for
MI Function
12-06-2
Description
1. IED-S uses the leveling sensor signals to ensure
the elevator leveling position. The elevator drive
system enables three configurations: single-door
sensor, upper/lower leveling sensor and
upper/lower door zone sensor.
2. When running upward, the elevator receives
upper leveling signal, door zone signal, and lower
leveling signal in sequence. When running
downward, the elevator receives lower leveling
signal, door zone signal, and upper leveling signal
in sequence.
3. LED indicator is ON when the sensor is covered.
1. Determines whether the elevator door opens or
not.
2. LED indicator is ON when the sensor is covered.
Contact B (N.C.) of FL1 contactor (Relay). Used to
Default: 0
Default: 0
Default: 0
Default: 1033
Default: 1035
Default: 1038
Default: 1034
Default: 15
Default: 18
Default: 21
Default: 9
Default: 8
Advertisement
Table of Contents
