Delta IED-S Series User Manual page 292

Pr.03-51
Setting Function
Value
0
Front door 1
1 Front door + disability 1
2
Front and rear door 1
Front and rear door + disability
3
–
1 16F
Main Landing at Flood
Settings
 Sets the physical floor that the elevator automatically runs above and stops when flood occurs.
For example, in a building with elevator from B2–5F, if you need to make the elevator
automatically run and stop at 5F, set Pr.03-52 to 7 when flood occurs; in a similar way, set
Pr.03-52 to 2 if you need the elevator to stop at floors other than B2 when flood occurs.
Function Set 1
Settings
 Setting method of LED display
Voice Announcer Bottom Floor Code
Settings
 Valid only when using parallel voice announcement.
 Example 1:
Assumes that the floor codes of voice announcer are as follows:
1: 0001 announces as floor B4
2: 0010 announces as floor B3
3: 0011 announces as floor B2
4: 0100 announces as floor B1
5: 0101 announces as floor 1
6: 0110 announces as floor 2
If the bottom floor is B1, set Pr.03-57=4; if the bottom floor is B3, set Pr.03-57=2.
 Example 2:
Assumes that the floor codes of voice announcer are as follows:
1: 0001 announces as floor B3
2: 0010 announces as floor B2
–
64F F 1
–
32F F 1
–
32F F 1
F 1
Note: Pr.03-51 synchronously enables or disables the corresponding hall calls
2–164S
2–64: Front door
102–164: Rear door
0–65535
1 (bit0): Adjusts the leveling switch position whenever the elevator runs
through the leveling switch
2 (bit1): Adjusts the deceleration switch position whenever the elevator runs
through the deceleration switch
4 (bit2): Automatically detects if the sequence of forced deceleration switch
action is correct
8 (bit3): Automatically checks the sequence of leveling switch action
Setting method of digital keypad KPC-CC01
0–64
12-03-11
Chapter 12 Descriptions of Parameter Settings | IED-S
The Installation Sequence for Car Command Board
1 2
– –
16F F 17 32F
– –
16F F 17 32F
– –
16F F 17 32F
– –
16F F+D 1 16F
* F: Front door / B: Rear door / D: Disability
3 4
– –
F 33 48F F 49 64F
– –
F+D 1 16F F+D 17 32F
B 1–16F –
B 17 32F
– –
B 1 16F B+D 1 16F
Default: 2
Default: 0
Default: 1