Delta IED-S Series User Manual page 260

Group Control of Each Elevator's Connection Status
Settings
 LED display
Elevator Running Direction
Settings
 LED display
Hoistway Auto-tuning Action Status
Settings
0000h–FFFFh
bit 0: Station number 0 is connected or not
bit 1: Station number 1 is connected or not
bit 2: Station number 2 is connected or not
bit 3: Station number 3 is connected or not
bit 4: Station number 4 is connected or not
bit 5: Station number 5 is connected or not
bit 6: Station number 6 is connected or not
bit 7: Station number 7 is connected or not
bit 8: Station number 0 is main group control or not
bit 9: Station number 1 is main group control or not
bit 10: Station number 2 is main group control or not
bit 11: Station number 3 is main group control or not
bit 12: Station number 4 is main group control or not
bit 13: Station number 5 is main group control or not
bit 14: Station number 6 is main group control or not
bit 15: Station number 7 is main group control or not
The display for digital keypad KPC-CC01
0000h–FFFFh
bit 0: Host controller (controller) runs upward
bit 1: Host controller (controller) runs downward
bit 2: Host controller (controller) makes drive run upward
bit 3: Host controller (controller) makes drive run downward
bit 4: Drive responds receiving upward commands
bit 5: Drive responds receiving downward commands
bit 6: Upward high-speed enabled command
bit 7: Downward high-speed enabled command
bit 8: Runs upward after stop
bit 9: Runs downward after stop
bit 10: Hall call displays an upward arrow
bit 11: Hall call displays a downward arrow
bit 12: Car call displays a upward arrow
bit 13: Car call displays a downward arrow
The display for digital keypad KPC-CC01
0–65535
0: Not in INSCP (control panel inspection switch) or EIS (electrical operation)
mode
12-00-11
Chapter 12 Descriptions of Parameter Settings | IED-S
Default: Read only
Default: Read only
Default: 0