Table of Contents
Advertisement
Chapter 11 Summary of Parameter Settings | IED-S
Pr.
Parameter Name
Setting Range
Default
149: BY2NC ON detection error
150: Unqualified braking force test
151: Operation contactor sticking
152: Runs with door open
153: Safety hatch low voltage error
154: Runs in an opposite direction
155: BK3 is not active
156: BY3NC ON detection error
157: Traveling cable insertion car communication
158: MPSCC feedback OFF error
159: SX2 door unlock OFF detection error
160: STO relay sticking
161: STO OFF error
162: BK1 is not reset
163: BK2 is not reset
164: BK3 is not reset
165: BK1 contactor sticking
166: BK2 contactor sticking
167: BK3 contactor sticking
168: Upward operation exceeds
169: Downward operation exceeds
170: SY door unlock output sticking
172 :Upward limit action
173: Upward forced deceleration 1
174: Upward forced deceleration 2
175: Upward forced deceleration 3
176: Downward limit action
177: Downward forced deceleration 1
178: Downward forced deceleration 2
179: Downward forced deceleration 3
180: Not at the bottom floor as displayed
181: Not at the top floor as displayed
182: At the bottom floor but not as displayed
183: At the top floor but not as displayed
184: Speed is slower than 0.01 m/s
185: All inputs are OFF
186: Upward forced deceleration 4
187: Downward forced deceleration 4
188: Starting signal abnormally disappears
11-8
Advertisement
Table of Contents
