Delta IED-S Series User Manual page 390

Code# KPC-CC01 Display
F144
Action
Related Parameters
Reset Method
Code# KPC-CC01 Display
F145
Action
Related Parameters
Reset Method
Code# KPC-CC01 Display
F146
Action
Related Parameters
Reset Method
Code# KPC-CC01 Display
F147
Action
Related Parameters
Reset Method
Code# KPC-CC01 Display
F148
Action
Related Parameters
Fault Name
Mismatched current Fault occurs when the floor for the host controller and
floor that for the drive is not identical as elevator stops
Action and Reset
Acts immediately
N/A
Returns to the top floor automatically, or resets automatically after adjusting floor
when returning to the top floor, or switch to the manual mode
Fault Name
The number of times
Fault occurs when the number of times that drive error
for drive error occurred
occur within one hour has reached five
has reached five
Action and Reset
Stops urgently
N/A
Press the RESET key on the digital keypad, press the external reset device, or
power-on again (choose either)
Fault Name
Drive communication Fault occurs when communication is not successfully
time-out connected with the drive within Pr.02-13 setting time
Action and Reset
Stops urgently
Pr.02-13 (CAN0 Communication Time-out)
Resets automatically once communication is normal
Fault Name
Fault occurs when communication between IED-S and
Communication
cartop board is not successfully connected within
between IED-S and
Pr.02-19 setting time. Error is not detected when in
cartop board
control panel manual mode.
Action and Reset
Stops urgently
Pr.02-19 (CAN2 Communication Time-out)
Resets automatically once the fault is cleared
Fault Name
Fault occurs when BY1NC (Brake-1 contactor
BY1NC ON detection
detection) signal is not OFF after brake contactor
error
activates (ON)
Action and Reset
Stops urgently
MI=27 BY1NC (N.C. contact of Brake-1 contactor)
14-9
Chapter 14 Fault Codes | IED-S
Description
Description
Description
Description
Description