Table of Contents
Advertisement
Chapter 9 Digital Keypad | IED-S
Display Item
1.
Parameter Setup
2.
Copy Parameter
Press ENTER to go to 001–004:
content storage
For example: Set the master frequency command source.
Display the Group 00 Motor Drive Parameter.
Use Up and Down to select parameter 20:
Auto Frequency Command.
Press ENTER to display the parameter's
setting menu.
Use Up and Down to choose a setting.
For example, choose 2 Analogue Input, and
then press ENTER.
After you press ENTER, the screen displays
"END", indicating that the new parameter
value is set.
Four groups of parameters are available to copy.
The steps are shown in the example below.
Example: Save parameters in the motor drive.
1. Go to Copy Parameter.
2. Select the parameter group to copy, and
then press ENTER.
1. Select 1: keypad->VFD.
2. Press ENTER to go to the "Save in the
motor drive" screen.
Copy parameters until it is done.
Once copying parameters is done, the
keypad automatically returns to this screen.
9-8
Advertisement
Table of Contents
