Delta IED-S Series User Manual page 165

Chapter 9 Digital Keypad | IED-S
Warning Codes
LCM Display *
Warning
CE01
Comm Command Er
Warning
CE02
Comm Address Er
Warning
CE03
Comm Data Error
Warning
CE04
Comm Slave Error
Warning
CE10
KpdCom m Time O ut
Warning
TPNO
TP No Object
*The content in this section only applies to the KPC-CC01 keypad V1.01 and later versions.
Description
Modbus function code error
Modbus data address error
Modbus data value error
Modbus slave drive error
Modbus transmission time-out
Object not supported by
TPEditor
Corrective Actions
Motor drive does not accept the communication
command sent from the keypad.
1. Verify that the keypad is properly connected to
the motor drive by a communication cable
such as RJ45.
2. Press RESET to clear the errors.
If none of the above solutions works, contact your
local authorized dealer for assistance.
Motor drive does not accept the keypad's
communication address.
1. Verify that the keypad is properly connected to
the motor drive by a communication cable
such as RJ45.
2. Press RESET to clear the errors.
If none of the above solutions works, contact your
local authorized dealer for assistance.
Motor drive does not accept the communication
data sent from the keypad.
1. Verify that the keypad is properly connected to
the motor drive by a communication cable
such as RJ45.
2. Press RESET to clear the errors.
If none of the above solution works, contact your
local authorized dealer for assistance.
Motor drive cannot process the communication
command sent from the keypad.
1. Verify that the keypad is properly connected to
the motor drive by a communication cable
such as RJ45.
2. Press RESET to clear the errors.
3. Shut down the system, wait for ten minutes,
and then restart the system.
If none of the above solutions works, contact your
local authorized dealer for assistance.
Motor drive does not respond to the
communication command sent from the keypad.
1. Verify that the keypad is properly connected to
the motor drive by a communication cable
such as RJ45.
2. Press RESET to clear the errors.
3. Shut down the system, wait for ten minutes,
and then restart the system.
If none of the above solutions works, contact your
local authorized dealer for assistance.
Keypad's TPEditor uses an unsupported object.
1. Verify that the TPEditor is not using an
unsupported object or setting. Delete
unsupported objects and unsupported
settings.
2. Re-edit the object in the TPEditor, and then
download it to the keypad.
If none of the above solutions works, contact your
local authorized dealer for assistance.
9-18