Delta IED-S Series User Manual page 389

Chapter 14 Fault Codes | IED-S
Related Parameters
Reset Method
Code# KPC-CC01 Display
F140
Action
Related Parameters
Reset Method
Code# KPC-CC01 Display
F141
Action
Related Parameters
Reset Method
Code# KPC-CC01 Display
F142
Action
Related Parameters
Reset Method
Code# KPC-CC01 Display
F143
Action
Related Parameters
Reset Method
N/A
Resets automatically
Fault Name
Motor temperature Fault occurs when there is an error in motor
error temperature
Action and Reset
Acts immediately
MI=50 MTS (Motor temperature overheat)
Resets automatically once the signal is normal
Fault Name
Fault occurs when the time that the elevator runs
continuously with any speed in any status exceeds
Pr.03-24 setting value. If the fault occurs in manual
mode, release the upward and downward operation
Exceeds the constant
buttons to make the elevator continue to run. Otherwise,
running time
the elevator resets automatically after it stops urgently
for five seconds. But if the number of fault occurred is
larger than Pr.03-23 within one hour, it will not reset
automatically.
Action and Reset
Stops urgently
Pr.03-23 (Number of Fault Reset), Pr.03-24 (Constant Running Protection Time)
Switch to the manual mode, press the RESET key on the digital keypad, press
the external reset device, or power-on again (choose either)
Fault Name
Governor error Fault occurs when governor activates
Action and Reset
Stops urgently
MI=55 GOV (Governor)
Resets automatically once the signal is normal
Fault Name
Fault occurs when the elevator runs at high speed, and
Exceeds specified floor
does not pass through or arrives at the specified floor
running time
within Pr.03-25 setting time
Action and Reset
Stops urgently
Pr.03-25 (Specified Floor Protection Time)
Switch to the manual mode, press the RESET key on the digital keypad, press
the external reset device, or power-on again (choose either)
14-8
Description
Description
Description
Description