Supplying Toner; Turning On The Main Power; Stirring The Toner - Canon imageRUNNER 7095 Service Manual

2.2.10 Supplying Toner

1) Open the hopper cover [1].
F-2-90
2) Peel off the packing tape from the machine.
3) Shift the toner cartridge locking lever [1] to the
left to release.
[1]
F-2-91
4) Hold the toner bottle [1] as shown, and turn the
cap [2] in the direction of the arrow to detach
the cap from the bottle.
Do not shake the toner bottle.
[2]
F-2-92
5) Fit the toner bottle [1] in place.
Be sure to push it until it stops.
0010-8961
[1]
[1]
F-2-93
6) Shift the toner cartridge locking lever [1] to the
right to lock it in place.
[1]
F-2-94
7) Close the hopper cover.

2.2.11 Turning On the Main Power

Be sure to remove all packing material from in-
side the cassette before turning on the main pow-
er.
1) Slide out the duplexing unit, and check to make
sure there is no foreign matter and damage.
2) Check to make sure that the main power switch
is at OFF; then, connect the machine's power
plug to the power outlet.
3) Turn on the main power switch by shifting it to
ON.
- A screen appears indicating that programs are
being loaded.
- A message appears indicating that the
machine is starting up.

2.2.12 Stirring the Toner

When the wait period is over, start service mode
to supply toner to the developing unit.
1) Start service mode. (
time > )
2) Make the following selections: COPIER >
FUNCTION > INSTALL > TONER-S.
3) See that the following message has appeared:
"Check the Developer."
4) Check to see that the developing assembly is
mounted properly; then, press the OK key.
- The supply operation lasts about 8 to 10 min,
Chapter 2
[1]
0011-6943
0011-1246
> '2' and '8' at the same
2-23