Delta C2000 Series User Manual page 870

API
GBIN
171
D P
Bit device
X Y M K
S *
D
Notes on operand usage:
Please refer to the function specifications table for each device in
series for the scope of device usage
S: source device used to store GRAY code. D: device used to store BIN value after

transformation.
The GRAY code corresponding to the value of the device designated by S is

transformed into a BIN value, which is stored in the device designated by D.
This command will transform the value of the absolute position encoder connected

with the PLC's input and (this encoder usually has an output value in the form of
GRAY code) into a BIN value, which is stored in the designated register.
The valid range of S is as shown below; if this range is exceeded, it will be

considered an error, and the command will not execute.
16-bit command: 0–32,767
32-bit command: 0–2,147,483,647

When X20=On, the GRAY code of the absolute position encoder connected with

input points X0 to X17 will be transformed into BIN value and stored in D10.
X20
GRAY CODE 6513
H1971=K6513
Word device
H KnX KnY KnM T
* * * * *
* * *
GBIN K4X0
X17
0 0 0 1
b15
0 0 0 1
Chapter 16 PLC Function ApplicationsC2000
GRAY code →BIN transformation
16-bit command (5 STEP)
GBIN Continuous
C D
execution type
* *
* *
32-bit command (9 STEP)
DGBIN Continuous
execution type
Flag signal: none

D10
K4X0
0 1 0 1 1 1 0 0 1 0 0
1 0 0 1 0 1 1 1 0 0 0 1
16-109
GBINP Pulse
execution type
DGBINP Pulse
execution type
X0
1
b0