12. Display setup
Unplug and plug back the keypad while copying the
PLC program will cause a CPLt warning.
Example: Saved in the keypad.
1. Go to "Copy PLC".
2. Select the parameter group which needs to be
copied and press ENTER key.
Press ENTER key to go to "Save in the motor drive"
screen.
If WPLSoft editor is installed and password is set,
enter the password to save the file onto digital
display.
Use Up/ Down key to select a symbol.
Use Left/ Right key to move the cursor to select a file
name.
String & Symbol Table:
!"#$%&'()*+,-./0123456789:;<=>?@A
BCDEFGHIJKLMNOPQRSTUVWXYZ[\]^_`ab
cdfghijklmnopqrstuvwxyz{|}~
Once the file name is confirmed, press ENTER key.
To begin copying parameters until it is done.
When copying parameters is completed, keypad will
automatically be back to this screen.
Press Right key to see the date of copying
parameters.
Press Right key to see the time of copying
parameters.
1. Contrast
10-17
Chapter 10 Digital KeypadC2000
Use Up / Down key to adjust the setting
value.