Delta C2000 Series User Manual page 313

Chapter 10 Digital KeypadC2000
10. PLC Function
Press Up/Down key to select a
PLC's function.
Then press ENTER.
11. Copy PLC
When the PLC function is activated or stopped, the PLC status will be
displayed on main page of Delta default setting.
Option 2: Enable PLC function
Factory setting on the main screen displays
PLC/RUN status bar.
Option 3: Disable PLC function
Factory setting on the main screen displays
PLC/STOP status bar
If the PLC program is not available in the control
board, PLFF warning will be displayed when
choosing option 2 or 3.
In this case, select option 1: No Function to clear
PLFF warning.
The PLC function of KPC-CE01 can only displays:
1. PLC0
2. PLC1
3. PLC2
4 duplicates are provided
The steps are shown in the example below.
Example: Saved in the motor drive.
1. Go to "Copy PLC"
2. Select a parameter group to copy, then press
ENTER.
1. Select 1: Save in the motor drive.
2. Press ENTER key to go to "Save in the motor
drive" screen.
Begin to copy PLC until it is done.
Once copying PLC is done, keypad will automatically
be back to this screen.
NOTE
If "Option 1: Save in the motor drive" is selected,
verify if the PLC program is built-in to KPC-CC01
keypad. If PLC program is not available in the keypad
while "Option 1: Save in the motor drive" is selected,
an "ERR8 Warning: Type not matching" will be
displayed on the screen.
10-16