Delta C2000 Series User Manual page 430

Settings Functions
Rotating speed
16
command form ACI
Rotating speed
17
command form AUI
Forced to Stop
18
(Pr. 07-20)
19 Digital up command
20 Digital down command
21 PID function disabled
22 Clear the counter
Input the counter value
23
(MI6)
24 FWD JOG command
25 REV JOG command
TQC / FOC mode
26
selection
27 ASR1/ ASR2 selection
Chapter 12 Description of Parameter SettingsC2000
ON: force the source of the frequency to be ACI. If the rotating
speed commands are set to AVI, ACI and AVI at the same time,
the priority is AVI > ACI.> AUI
ON: force the source of the frequency to be AUI. If the rotating
speed commands are set to AVI, ACI and AVI at the same time,
the priority is AVI > ACI.> AUI
ON: the drive ramps to stop according to the Pr.07-20 setting.
ON: the frequency of the drive increases or decreases by one
unit. If this function remains ON continuously, the frequency
increases or decreases according to Pr.02-09 / Pr.02-10.
The Frequency command returns to zero when the drive stops,
and the displayed frequency is 0.00 Hz. If you select Pr.11-00, bit
7 = 1, the frequency is not saved.
ON: the PID function is disabled.
ON: the current counter value is cleared and displays 0. The
drive counts up when this function is disabled.
On: the counter value increases by 1. Use the function with
Pr.02-19.
This function is valid when the source of the operation command
is external terminal. ON: the drive executes forward JOG. When
executing the JOG command in torque mode, the drive
automatically switches to speed mode. The drive returns to
torque mode after the JOG command is complete.
This function is valid when the source of the operation command
is external terminal. ON: the drive executes reverse JOG. When
executing the JOG command in torque mode, the drive
automatically switches to speed mode. The drive returns to
torque mode after the JOG command is complete.
ON: TQC mode.
OFF: FOC mode.
ON: the speed is adjusted by the ASR 2 setting. OFF: the speed
is adjusted by the ASR 1 setting. Refer to Pr.11-02 for details.
12.1-02-5
Descriptions