Delta C2000 Series User Manual page 429

Chapter 12 Description of Parameter SettingsC2000
Settings Functions
Acceleration/deceleration
7
Speed Inhibit
The 1 , 2
st
8 deceleration time
selection
The 3 , 4
rd
9 deceleration time
selection
EF Input
10
(EF: External Fault)
Base block (B.B.) input
11
from external
Output Stop
12
(Output pause)
Cancel the setting of
13 auto-acceleration /
auto-deceleration time
Switch between motor 1
14
and motor 2
Rotating speed
15
command form AVI
When you enable this function, the drive stops acceleration or
deceleration immediately. After you disable this function, the AC
motor drive starts to accelerate or decelerate from the inhibit
point.
acceleration /
nd
You can select the acceleration and deceleration time of the drive
with this function, or from the digital status of the terminals; there
acceleration /
th
are four acceleration and deceleration selections.
For external fault input. The drive decelerates according to the
Pr.07-20 setting, and the keypad shows "EF" (it shows the fault
record when an external fault occurs). The drive keeps running
until the fault is cleared (terminal status restored) after RESET.
ON: the output of the drive stops immediately. The motor is in
free run and the keypad displays the B.B. signal. Refer to
Pr.07-08 for details.
When the switch is ON, output of the drive stops immediately
and the motor is in free run status. The drive is in output waiting
status until the switch is turned to OFF, and then the drive
restarts and runs to the current setting frequency.
Set Pr.01-44 to one of the 01–04 setting modes before using this
function. When this function is enabled, OFF is for auto mode
and ON is for linear acceleration / deceleration.
When the contact of this function is ON: use motor 2 parameters.
OFF: use motor 1 parameters.
ON: force the source of the frequency to be AVI. If the rotating
speed commands are set to AVI, ACI and AUI at the same time,
the priority is AVI > ACI > AUI.
Descriptions
12.1-02-4