Delta C2000 Series User Manual page 339

Chapter 11 Summary of Parameter SettingsC2000
Pr. Parameter Name
Coefficient gain in actual output
00-05

frequency
00-06 Software version
Parameter protection password
00-07

input
Setting Range
24: Position command tracing error (E.)
25: Overload count (0.00~100.00%) (o.) (Unit: %)
26: Ground fault GFF (G.) (Unit: %)
27: DC BUS voltage ripple (r.) (Unit: V
28: Display PLC data D1043 (C)
29: Display PM pole section (EMC-PG01U
application) (4.)
30: Display output of user defined (U)
31: Display Pr. 00-05 user gain (K)
32: Number of actual motor revolution during
operation (PG card plug in and Z phase signal
input) (Z.)
33: Motor actual position during operation (when PG
card is connected) (q)
34: Operation speed of fan (F.) (Unit: %)
35: Control mode display:
0 = Speed control mode (SPD)
1 = Torque control mode (TQR) (t.)
36: Present operating carrier frequency of drive (Hz)
(J.)
38: Display drive status (6.)
39: Display estimated output torque, positive and
negative, using Nt-m as unit (t 0.0: positive
torque; -0.0: negative torque (C.)
40: Torque command (L.) (Unit: %)
41: kWh display (J) (Unit: kWh)
42: PID target value (h.) (Unit: %)
43: PID offset (o.) (Unit: %)
44: PID output frequency (b.) (Unit: Hz)
45: Hardware ID
49: Motor temperature (PTC, PT100, KTY84-130)
51: PMSVC torque offset
52: AI10%
53: AI11%
0.00–160.00
Read only
0–65535
0–4: the number of password attempts allowed
11-4
Default
)
DC
1.00
Read
only
0