Delta C2000 Series User Manual page 276

8-16-5 To set the communication parameters when C2000 connects with PROFINET
When you operate VFD-C2000 through CMC-PN01, you should set the communication card as
the source of VFD-C2000 controls and settings. You need to use the keypad to configure the
following parameter addresses to the corresponding values:
Parameters
Pr.00-20
Pr.00-21
Pr.09-30
Pr.09-60
8-16-6 LED indicator introduction
Name
Ready out indicator Yellow LED
MT out indicator
SD indicator
BF out indicator
ACT PHY1
indicator
LINK PHY1
indicator
ACT PHY2
indicator
LINK PHY2
indicator
Setting value
The frequency command is controlled by communication card
8
The frequency command is controlled by communication card
5
Use decoding method (60xx or 20xx)
1
Communication card identification:
When CMC-PN01 communication card is connected, the value
12
of this parameter displays "12".
Indicator status
Always on
Flashing
Off
Green LED
Red LED
Always on
Flashing
Red LED
Off
Always on
Orange LED
Flashing
Off
Always on
Green LED
Off
Always on
Orange LED
Flashing
Off
Always on
Green LED
Off
Description
PN Stack starts normally
PN Stack starts normally, and waiting
for syncing with MCU
PN Stack failed to start
- -
- -
Connection with PROFINET Controller
is interrupted
Connection is in normal state, but the
communication
Controller is abnormally
Connection with PROFINET Controller
is in normal state
It's online, and exchanging the data
with Master normally
It's offline, but hand shaking the data
with Master
Initial state
Internet connection is in normal state
Doesn't connect to network
It's online, and exchanging the data
with Master normally
It's offline, but hand shaking the data
with Master
Initial state
Internet connection is in normal state
Doesn't connect to network
8-43
Chapter 8 Option CardsC2000
Indication
with PROFINET