Delta C2000 Series User Manual page 303

Chapter 10 Digital KeypadC2000
1. Parameter Setup
Press to select.
Press to select a parameter group.
Once a parameter group is selected,
press to go into that group.
2. Quick Start
Press to select.
Quick Start:
1. V/F Mode
2. VFPG Mode
3. SVC Mode
4. FOCPG Mode
5. TQCPG Mode
6. My Mode
For example: Setup source of master frequency command.
Description:
1. VF Mode
01:Password Decoder
10-6
Once in the Group 00 Motor Drive Parameter,
Use Up/Down key to select parameter 20:
Auto Frequency Command.
When this parameter is selected, press
ENTER key to go to this parameter's setting
menu.
Use Up/Down key to choose a setting.
For example: Choose "2 Analogue Input",
then press the ENTER key.
After pressing the ENTER key, an END will be
displayed which means that the parameter
setting is done.
NOTE: When parameter lock/ password
protection function is enabled, it will display
"Pr. lock" on the right-up corner of the keypad.
The parameter cannot be written or is
protected by the password under this
circumstances.
Items
1. Parameter Protection Password Input
(Pr. 00-07)
2. Parameter Protection Password Setting
(Pr. 00-08)
3. Control Mode (Pr. 00-10)
4. Control of Speed Mode (Pr. 00-11)
5. Load Selection (Pr. 00-16)
6. Carrier Frequency (Pr. 00-17)
7. Source of the Master Frequency
Command (AUTO) (Pr. 00-20)
8. Source of the Operation Command
(AUTO) (Pr. 00-21)
9. Stop Method (Pr. 00-22)
10. Digital Keypad STOP function (Pr.00-32)
11. Max. Operation Frequency (Pr. 01-00)
12. Base Frequency of Motor 1 (Pr. 01-01)
13. Max. Output Voltage Setting of Motor 1
(Pr. 01-02)
14. Middle Output Frequency of Motor 1
(Pr. 01-03)
15. Middle Output Voltage of Motor 1
(Pr. 01-04)
16. Middle Output Frequency of Motor 2
(Pr. 01-05)
17. Middle Output Voltage of Motor 2
(Pr. 01-06)
18. Min. Output Frequency of Motor 1
(Pr. 01-07)
19. Min. Output Voltage of Motor 1
(Pr. 01-08)
20. Output Frequency Upper Limit
(Pr. 01-10)