Delta C2000 Series User Manual page 272

Environment
Noise immunity
Operation
Storage
Vibration / shock
immunity
8-15-4 RJ-45 PIN Definition
RJ-45
8-15-5 Communication Parameters for VFD-C2000 Connected to EtherCAT
When operating VFD-C2000 via CMC-EC01, please set the control and operation command as
controlled by communication card. When C2000 is connected to EtherCAT network, please set up
the communication parameters according to the table below.
Parameter
Pr. 00-20
Pr. 00-21
Pr. 09-60
Pr. 09-61
8-15-6 LED Indicator
LED
POWER
LINK
ESD (IEC 61800-5-1, IEC 61000-4-2)
EFT (IEC 61800-5-1, IEC 61000-4-4)
Surge Test (IEC 61800-5-1, IEC 61000-4-5)
Conducted Susceptibility Test (IEC 61800-5-1, IEC 61000-4-6)
–
-10°C 15°C (temperature), 90% (humidity)
–
-25°C 70°C (temperature), 95% (humidity)
International standard: IEC 61800-5-1, IEC 60068-2-6 / IEC 61800-5-1,
IEC 60068-2-27
PIN No. Signal
1 Tx+
2 Tx-
3 Rx+
4 --
5 --
6 Rx-
7 --
8 --
Set value (Dec)
8 The frequency command is controlled by communication card.
5 The operation command is controlled by communication card.
Identification: when CMC-EC01 is connected, Pr.09-60 will show
6
value 6 (EtherCAT Slave)
-- Version of communication card
Status
On
Green
Off
On
Green Flashes
Off
Definition
Positive pole for data transmission
Negative pole for data transmission
Positive pole for data receiving
N / C
N / C
Negative pole for data receiving
N / C
N / C
Explanation
Indication
Power supply in normal status
No power supply
Operate in normal status
Pre-operation (On / Off 200ms)
Operate in safe mode
(On 200ms / Off 1000ms)
Initial state
8-39
Chapter 8 Option CardsC2000