Delta C2000 Series User Manual page 640

ID No. Display on LCM Keypad
22_1
Action level
Action time
Warning setting parameter
Reset method
Reset condition
Record
Cause
Motor locked
The load is too large
Ambien temperature is too high
Motor cooling system error
Motor fan error
Operates at low-speed too long
Accel./ Decel. time and working
cycle is too short
V/F voltage is too high
Check if the motor rated current
matches the motor nameplate
Check if the PTC is properly set
and wired
Check if the setting for stall
prevention is correct
Unbalance three-phase
impedance of the motor
Harmonics is too high
Warning Name
Motor over-heating warning.
Motor over-heating
The AC motor drive detects the temperature inside the
(oH3) PTC
motor is too high
Action and Reset
Pr. 03-00=6 (PTC), PTC input level > Pr. 06-30 (default=50%)
Immediately act
Error treatment: Pr. 06-29
0: Warn and keep operating
1: Warn and ramp to stop
2: Warn and coast to stop
3: No warning
When Pr. 06-29=0 and when the temperature is ≦ Pr. 06-30 level, the oH3
warning automatically clears.
When Pr. 06-29=0 ("Warning"), it automatically resets.
When Pr. 06-29=0, oH3 displays "Warning". When the temperature is ≦ Pr.
06-30 level, the oH3 warning automatically clears.
When the temperature is ≦ Pr. 06-30 level, the oH3 warning automatically
clears.
N/A
Clear the motor lock status.
Decrease the loading.
Replace with a motor with larger capacity.
Change the installed place if there are heating devices in the surroundings.
Install/ add cooling fan or air conditioner to lower the ambient temperature.
Check the cooling system to make it work normally.
Replace the fan.
Decrease low-speed operation time.
Change to dedicated motor for the drive.
Increase the motor capacity.
Increase setting values for Pr. 01-12–01-19 (accel./ decel. time).
Adjust settings for Pr. 01-01–01-08 (V/F curve), especially the setting value for
the mid-point voltage (if the mid-point voltage is set too small, the load capacity
decreases at low-speed).
Configure the correct rated current value of the motor again.
Check the connection between PTC thermistor resistor and the heat protection.
Set the stall prevention to the proper value.
Replace the motor.
Use remedies to reduce harmonics.
13-13
Chapter 13 Warning CodesC2000
Description
Corrective Actions