Delta C2000 Series User Manual page 307

Chapter 10 Digital KeypadC2000
6. My Mode
Click F4 in parameter
setting page, the
parameter will be saved
to My Mode. To delete or
correct the parameter,
enter this parameter and
click the "DEL" on the
bottom right corner.
10-10
13. Pole Number of Induction Motor 1
(Pr. 05-04)
14. No-load Current of Induction Motor 1
(Pr. 05-05)
15. Over-voltage Stall Prevention
(Pr. 06-01)
16. Software Brake Level (Pr. 07-00)
17. Encoder Type Selection (Pr. 10-00)
18. Encoder Pulse (Pr. 10-01)
19. Encoder Input Type Setting (Pr. 10-02)
20. System Control (Pr. 11-00)
21. Per Unit of System Inertia (Pr. 11-01)
22. ASR1 Low-speed Bandwidth
(Pr. 11-03)
23. ASR2 High-speed Bandwidth
(Pr. 11-04)
24. Zero-speed Bandwidth (Pr. 11-05)
25. Max. Torque Command (Pr. 11-27)
26. Source of Torque Offset (Pr. 11-28)
27. Torque Offset Setting (Pr. 11-29)
28. Source of Torque Command (Pr. 11-33)
29. Torque Command (Pr. 11-34)
30. Speed Limit Selection (Pr. 11-36)
31. Forward Speed Limit (torque mode)
(Pr. 11-37)
32. Reverse Speed Limit (torque mode)
(Pr. 11-38)
Items
It can save 01~32 sets of parameters (Pr).
Setup process
1. Go to "Parameter Setup" function.
Press ENTER to go to the parameter
which you need to use. There is an ADD
on the bottom right-hand corner of the
screen. Press F4 on the keypad to add
this parameter to My Mode.
00- 10
0
Speed M ode
0~3
2. The parameter (Pr) will be displayed in
My mode if it is properly saved.
To correct or to delete this Pr., click
3. To delete a parameter, go to "My Mode"
and select a parameter which you need
to delete.
Press ENTER to enter the parameter
setting screen. There is a DEL on the
A DD
DEL.