Delta C2000 Series User Manual page 806

Command
Drive coil
OUT
X0–X17
Operand
－
Outputs result of logical operation before OUT command to the designated element.
Coil contact action:
Result:
FALSE
TRUE
Ladder diagram:
X0
Command
Action continues (ON)
SET
X0–X17
Operand
－
When the SET command is driven, the designated element will be set as On, and will
be maintained in an On state, regardless of whether the SET command is still driven.
The RST command can be used to set the element as Off.
Ladder diagram:
X0
Command
Clear contact or register
RST
X0–X17
Operand
－
When the RST command is driven, the action of the designated element will be as
follows:
Element
Y, M Both coil and contact will be set as Off.
The current timing or count value will be set as 0, and both the coil
T, C
and contact will be set as Off.
D The content value will be set as 0.
If the RST command has not been executed, the status of the designated element will
remain unchanged.
Ladder diagram:
X0
Y0–Y17 M0–M799
 
Out command
Coil
Contact a (NO)
Off Not conducting
On Conducting
X1
Y1
Y0–Y17 M0–M799
 
Y0
Y1
SET
Y0–Y17 M0–M799
 
Y5
RST
16-45
Chapter 16 PLC Function ApplicationsC2000
Function
T0–159
－
Access Point:
Contact b (NC)
Conducting
Not conducting
Command code:
LD X0
AND X1
OUT Y1
Function
T0–159
－
Command code:
LD X0
AN Y0
SET Y1
Function
T0–159

Mode
Command code:
LD X0
RST Y5
C0–C79 D0–D399
－ －
Description:
Load Contact b of X0
Establish parallel
connection to contact a
of X1
Drive Y1 coil
C0–C79 D0–D399
－ －
Description:
Load Contact a of X0
Establish parallel
connection to contact b
of Y0
Action continues (ON)
C0–C79 D0–D399
 
Description:
Load Contact a of X0
Clear contact or
register