Delta C2000 Series User Manual page 269

Chapter 8 Option CardsC2000
Parameter
Pr. 09-80
Pr. 09-81
Pr. 09-82
Pr. 09-83
Pr. 09-84
Pr. 09-85
Pr. 09-86
Pr. 09-87
8-14-6 LED Indicator & Troubleshooting
There are 2 LED indicators on the CMC-EIP01. The POWER LED displays the status of
power supply, and the LINK LED displays the connection status of the communication.
LED Indicators
LED
POWER Green
LINK Green
Troubleshooting
Abnormality
POWER LED off
LINK LED off
No communication
card found
Fail to open
CMC-EIP01 setup
page
Function
Netmask -1
Netmask -2
Netmask -3
Netmask -4
Default gateway -1
Default gateway -2
Default gateway -3
Default gateway -4
Status
On Power supply in normal status
Off No power supply
Network connection in normal
On
status
Flashing Network in operation
Off Network not connected
Cause
AC motor drive not powered
CMC-EIP01 not connected to
AC motor drive
CMC-EIP01 not connected to
network
Poor contact to RJ-45
connector
CMC-EIP01 not connected to
network
PC and CMC-EIP01 in
different networks and blocked
by network firewall.
CMC-EIP01 not connected to
network
Incorrect communication
setting in DCISoft
PC and CMC-EIP01 in
different networks and blocked
by network firewall.
Set value (Dec)
255 Netmask 255.255.255.0
255 Netmask 255.255.255.0
255 Netmask 255.255.255.0
0 Netmask 255.255.255.0
192 Default gateway 192.168.1.1
168 Default gateway 192.168.1.1
1 Default gateway 192.168.1.1
1 Default gateway 192.168.1.1
Indication
Check if AC motor drive is powered, and if the
power supply is normal.
Make sure CMC-EIP01 is connected to AC motor
drive.
Make sure the network cable is correctly connected
to network.
Make sure RJ-45 connector is connected to
Ethernet port.
Make sure CMC-EIP01 is connected to network.
Search by IP or set up relevant settings by AC
motor drive keypad.
Make sure CMC-EIP01 is connected to the
network.
Make sure the communication setting in DCISoft is
set to Ethernet.
Conduct the setup by AC motor drive keypad.
8-36
Explanation
How to correct it?
--
Check the power supply.
--
--
Check if the network cable is
connected.
How to correct it?