Delta C2000 Series User Manual page 541

Chapter 12 Description of Parameter SettingsC2000
Wake-up Frequency

Settings
 When Pr. 08-18 = 0, the unit for Pr. 08-10 and that for Pr. 08-11 switch to frequency. The settings
are become 0–600.00 Hz.
 When Pr. 08-18=1, the unit for Pr. 08-10 and that for Pr. 08-11 switch to percentage. The
settings then are to 0–200.00%.
 The percentage is based on the current command value, not the maximum value. For example,
if the maximum value is 100 kg, and the current value is 30kg, then if Pr. 08-11 = 40%, the value
is 12 kg.
 Pr. 08-10 uses the same logic for calculation.
Sleep Time

Settings
 When the frequency command is smaller than the sleep frequency and less than the sleep time,
the frequency command is equal to the sleep frequency. However, the frequency command
remains at 0.00 Hz until the frequency command becomes equal to or larger than the wake-up
frequency.
PID Deviation Level

Settings
PID Deviation Time

Settings
 When the PID control function is normal, it should calculate the value within a period of time that
is close to the target value.
 Refer to the PID control diagram for details. When executing PID feedback control, if |PID
reference target value – detection value| > Pr. 08-13 PID Deviation Level and exceeds Pr. 08-14
setting, it is judged as a PID control fault, and the multi-function output MOx = 15 (PID feedback
error) activates.
PID Feedback Filter Time

Settings
PID Compensation Selection

Settings
 0: The setting for Pr. 08-17 gives the PID compensation value.
 1: Set the analog input (Pr. 03-00–03-02) to 13, then the PID compensation value of analog
input is displayed on Pr. 08-17. At this time, Pr. 08-17 is read only).
0.00–599.00 Hz
0.0–6000.0 sec.
1.0–50.0%
0.1–300.0 sec.
0.1–300.0 sec.
0: Parameter setting (Pr. 08-17)
1: Analog input
12.1-08-8
Default: 0.00
Default: 0.0
Default: 10.0
Default: 5.0
Default: 5.0
Default: 0