Subaru Legacy 2002 Service Manual page 1073

Mechanical
2) Install camshaft cap.
(1) Apply fluid packing sparingly to back of front
camshaft cap shown in the figure.
CAUTION:
Do not apply fluid packing excessively. Failure
to do so may cause excess packing to come
out and flow toward oil seal, resulting in oil
leaks.
Fluid packing:
THREE BOND 1280B
Fluid packing application diameter:
2.0±0.5 mm (0.079±0.020 in)
(2) Apply engine oil to cap bearing surface and
install cap on camshaft.
(3) Tighten the camshaft cap bolts in the
numerical sequence shown in the figure.
Tightening torque:
16 N·m (1.6 kgf-m, 11.6 ft-lb)
(4) Tighten the front camshaft cap bolts in the
numerical sequence shown in the figure.
Tightening torque:
9.8 N·m (1.0 kgf-m, 7.2 ft-lb)
CAMSHAFT
3) Install rocker cover.
(1) Apply fluid packing sparingly to matching
surface of cylinder heads and rocker covers
shown in the figure.
CAUTION:
Do not apply fluid packing excessively. Doing
so may cause excess packing to come out and
flow toward oil seal, resulting in oil leaks.
Fluid packing:
THREE BOND 1280B
B2M4066A
B2M4064B
ME(H6)-52
B2M4063B
B2M4067A