Subaru Legacy 2002 Service Manual page 1077

Mechanical
9) Install crankshaft pulley. <Ref. to ME(H6)-39,
INSTALLATION, Crankshaft Pulley.>
C: DISASSEMBLY
1) Place cylinder head on ST.
ST 18250AA000 CYLINDER HEAD TABLE
2) Remove valve shims and valve lifters.
3) Set ST on valve spring. Compress valve spring
and remove the valve spring retainer key. Remove
each valve and valve spring.
ST 499718000 VALVE SPRING REMOVER
CAUTION:
¼ For correct re-installation, keep removed
parts in order in their original positions.
¼ Mark each valve to prevent confusion.
¼ Use extreme care not to damage the lips of
the intake valve oil seals and exhaust valve oil
seals.
D: ASSEMBLY
S143093A02
1) Installation of valve spring and valve
(1) Place cylinder head on ST.
ST 18250AA000 CYLINDER HEAD TABLE
(2) Coat stem of each valve with engine oil and
insert valve into valve guide.
CAUTION:
When inserting valve into valve guide, use spe-
cial care not to damage the oil seal lip.
(3) Install valve spring and retainer.
CAUTION:
¼ Be sure to install the valve springs with their
close-coiled end facing the seat on the cylinder
head.
¼ Install valve spring with the painted surface
facing the retainer side.
CYLINDER HEAD ASSEMBLY
S143093A06
B2M4071A
ME(H6)-56
(1) Seat
(2) Valve spring
(3) Retainer
(4) Painted face
(4) Set ST on valve spring.
ST 499718000 VALVE SPRING REMOVER
(5) Compress valve spring and fit valve spring
retainer key.
(6) After installing, tap valve spring retainers
lightly with wooden hammer for better seating.
2) Apply oil to the surface of the valve lifter and
valve shim.
3) Install valve lifter and valve shim.
B2M4072A
B2M4071A