Subaru Legacy 2002 Service Manual page 1074

(2) Tighten the rocker cover bolts in the numeri-
cal order shown in the figure.
Tightening torque:
6.4 N·m (0.64 kgf-m, 4.6 ft-lb)
4) Install rear chain cover. <Ref. to ME(H6)-49,
INSTALLATION, Rear Chain Cover.>
5) Install crankshaft sprocket. <Ref. to ME(H6)-48,
INSTALLATION, Crankshaft Sprocket.>
6) Install camshaft sprockets. <Ref. to ME(H6)-47,
INSTALLATION, Camshaft Sprocket.>
7) Install timing chain assembly. <Ref. to ME(H6)-
43, INSTALLATION, Timing Chain Assembly.>
8) Install front chain cover. <Ref. to ME(H6)-40,
INSTALLATION, Front Chain Cover.>
9) Install crankshaft pulley. <Ref. to ME(H6)-39,
INSTALLATION, Crankshaft Pulley.>
CAMSHAFT
C: INSPECTION
1. CAMSHAFT
1) Measure the bend, and repair or replace if nec-
essary.
Limit:
0.020 mm (0.0008 in)
2) Check journal for damage and wear. Replace if
faulty.
3) Measure outside diameter of camshaft journal.
If the journal diameter is not as specified, check the
oil clearance.
B2M4068A
Standard
4) Measurement of the camshaft journal oil clear-
ance
(1) Clean the bearing caps and camshaft jour-
nals.
(2) Place the camshafts on the cylinder head.
(Without installing valve rocker.)
(3) Place plastigauge across each of the cam-
shaft journals.
(4) Install the bearing caps.
CAUTION:
Do not turn the camshaft.
(5) Remove the bearing caps.
ME(H6)-53
S143092A10
S143092A1001
Camshaft journal
Front Center, rear
37.946 — 37.963 mm 27.946 — 27.963 mm
(1.4939 — 1.4946 in) (1.1002 — 1.1009 in)
Mechanical
B2M4069