Subaru Legacy 2002 Service Manual page 1087

Mechanical
17) Install oil strainer.
NOTE:
Use a new O-ring.
18) Apply fluid packing to mating surface of lower
oil pan.
Fluid packing:
THREE BOND 1280B
Fluid packing application diameter:
5.0±1.0 mm (0.097±0.039 in)
19) Tighten the lower oil pan mounting bolts in the
numerical sequence shown in the figure.
Tightening torque:
6.4 N·m (0.65 kgf-m, 4.7 ft-lb)
CYLINDER BLOCK
20) Install crankshaft position sensor bracket.
Tightening torque:
6.4 N·m (0.65 kgf-m, 4.7 ft-lb)
B2M4081
21) Install crankshaft position sensor plate.
22) Install drive plate.
Using ST, lock crankshaft.
ST 498497100 CRANKSHAFT STOPPER
Tightening torque:
B2M4097
81 N·m (8.3 kgf-m, 60 ft-lb)
23) Install cylinder head assembly. <Ref. to
ME(H6)-55,
Assembly.>
24) Install
B2M4080A
INSTALLATION, Camshaft.>
25) Install rear chain cover. <Ref. to ME(H6)-49,
INSTALLATION, Rear Chain Cover.>
26) Install crankshaft sprocket. <Ref. to ME(H6)-
48, INSTALLATION, Crankshaft Sprocket.>
27) Install camshaft sprockets. <Ref. to ME(H6)-
47, INSTALLATION, Camshaft Sprocket.>
ME(H6)-66
INSTALLATION, Cylinder
camshafts. <Ref. to
B2M4079
B2M4078
B2M4077A
Head
ME(H6)-51,