Immobilizer Indicator Light; Drive Indicator Light (If Equipped); Select Lever/Gear Position Indicator - Subaru Outback 2011 Owner's Manual

3-36
Instruments and controls
&
Immobilizer indicator
light
This light begins flashing under any of the
following conditions.
. Approximately 60 seconds after the
ignition switch is turned from the "ON"
position to the "Acc" or "LOCK" position
(models without "keyless access with
push-button start system").
. Immediately after the push-button igni-
tion switch is turned to the "OFF" position
(models with "keyless access with push-
button start system").
. Immediately after the key is pulled out
(models without "keyless access with
push-button start system").
. Immediately after any door is opened
when the push-button ignition switch is in
the "Acc" position (models with "keyless
access with push-button start system").
If the indicator light does not blink, it may
indicate that immobilizer system is not
working properly. We recommend that you
contact your nearest SUBARU dealer
immediately.
In case an unauthorized key is used, the
immobilizer indicator light illuminates.
& SI-DRIVE indicator light (if
equipped)
1) Intelligent (I) mode
2) Sport (S) mode
3) Sport Sharp (S#) mode
This light indicates the current SI-DRIVE
mode.
For details of SI-DRIVE mode, refer to "SI-
DRIVE" F7-25.
& Select lever/gear position in-
dicator
This indicator shows the position of the
shift lever (MT models) or select lever (AT
and CVT models).
! AT and CVT models
When the manual mode is selected, the
gear position indicator (which shows the
current gear selection) and the upshift/
downshift indicator light up. Refer to
"Automatic transmission/Continuously
variable transmission" F7-19.
! MT models
The shift-up indicator light illuminates and
informs the driver about the upshift timing
for fuel-efficient driving.
The gear position indicator and shift-up