Compulsory Valve Operation Check Mode - Subaru 2004 Impreza Service Manual

ENGINE (DIAGNOSTICS)
15.Compulsory Valve Operation
Check Mode
A: OPERATION
1) Prepare the Subaru Select Monitor kit. <Ref. to
EN(H4DOTC)(diag)-8,
General Description.>
2) Connect the diagnosis cable to Subaru Select
Monitor.
3) Insert the cartridge into Subaru Select Monitor.
<Ref. to EN(H4DOTC)(diag)-8, PREPARATION
TOOL, General Description.>
4) Connect the test mode connector (A) at the low-
er portion of instrument panel (on the driver's side).
(A)
5) Connect the Subaru Select Monitor to data link
connector.

Compulsory Valve Operation Check Mode

PREPARATION TOOL,
EN-00038
EN-00039
EN-01288
EN(H4DOTC)(diag)-48
(1) Connect the Subaru Select Monitor to data
link connector located in the lower portion of in-
strument panel (on the driver's side).
(2) Connect the diagnosis cable to data link
connector.
CAUTION:
Do not connect scan tools except for the Suba-
ru Select Monitor and OBD-II general scan tool.
6) Turn the ignition switch to ON (engine OFF) and
Subaru Select Monitor switch to ON.
(A) Power switch
7) On the «Main Menu» display screen, select the
{2. Each System Check} and press the [YES] key.
8) On the «System Selection Menu» display
screen, select the {Engine Control System} and
press the [YES] key.
9) Press the [YES] key after the information of en-
gine type is displayed.
10) On the «Engine Diagnosis» display screen, se-
lect the {System Operation Check Mode} and press
the [YES] key.
11) On the «System Operation Check Mode» dis-
play screen, select the {Actuator ON/OFF Opera-
tion} and press the [YES] key.
12) Select the desired compulsory actuator on the
«Actuator ON/OFF Operation» display screen and
press the [YES] key.
13) Pressing the [NO] key completes the compul-
sory operation check mode. The display will then
return to the «Actuator ON/OFF Operation»
screen.
IM-00072
(A)
EN-00040