Compulsory Valve Operation Check Mode - Subaru IMPREZA 2004 Service Manual

ENGINE (DIAGNOSTICS)
15.Compulsory Valve Operation
Check Mode
A: OPERATION
1) Prepare the Subaru Select Monitor kit. <Ref. to
EN(H4SO)(diag)-8, PREPARATION TOOL, Gen-
eral Description.>
2) Connect the diagnosis cable to Subaru Select
Monitor.
3) Insert the cartridge into Subaru Select Monitor.
<Ref. to EN(H4SO)(diag)-8,
TOOL, General Description.>
4) Connect the test mode connector (A) at the low-
er portion of instrument panel (on driver's side).
(A)
5) Connect the Subaru Select Monitor to data link
connector.

Compulsory Valve Operation Check Mode

EN-00038
PREPARATION
EN-00039
EN-01164
EN(H4SO)(diag)-48
(1) Data link connector is located in the lower
portion of instrument panel (on driver's side).
(2) Connect the diagnosis cable to data link
connector.
CAUTION:
Do not connect scan tools except for Subaru
Select Monitor and OBD-II general scan tool.
6) Turn the ignition switch to ON (engine OFF) and
Subaru Select Monitor switch to ON.
(A) Power switch
7) On «Main Menu» display screen, select the {2.
Each System Check} and press the [YES] key.
8) On «System Selection Menu» display screen,
select the {Engine Control System} and press the
[YES] key.
9) Press the [YES] key after the information of en-
gine type is displayed.
10) On «Engine Diagnosis» display screen, select
the {System Operation Check Mode} and press the
[YES] key.
11) On «System Operation Check Mode» display
screen, select the {Actuator ON/OFF Operation}
and press the [YES] key.
12) Select the desired compulsory actuator on the
«Actuator ON/OFF Operation» display screen and
press the [YES] key.
IM-00072
(A)
EN-00040