Compulsory Valve Operation Check Mode - Subaru LEGACY 2004 Service Manual

14.Compulsory Valve Operation
Check Mode
A: OPERATION
1) Prepare the Subaru Select Monitor kit. <Ref. to
EN(H6DO)(diag)-7, PREPARATION TOOL, Gen-
eral Description.>
2) Connect the diagnosis cable to Subaru Select
Monitor.
3) Insert the cartridge to Subaru Select Monitor.
<Ref. to EN(H6DO)(diag)-7,
TOOL, General Description.>
4) Connect the test mode connector (A) located at
the lower portion of glove box.

Compulsory Valve Operation Check Mode

EN-00038
PREPARATION
EN-00039
(A)
EN-02424
EN(H6DO)(diag)-41
5) Connect the Subaru Select Monitor to data link
connector located in the lower portion of the instru-
ment panel (on the driver's side).
CAUTION:
Do not connect the scan tools except for Suba-
ru Select Monitor or OBD-II general scan tool.
6) Turn ignition switch to ON (engine OFF) and turn
on the Subaru Select Monitor switch.
(A) Power switch
7) On the «Main Menu» display screen, select the
{Each System Check} and press the [YES] key.
8) On the «System Selection Menu» display
screen, select the {Engine} and press the [YES]
key.
9) Press the [YES] key after the information of en-
gine type was displayed.
10) On the «Engine Diagnosis» display screen, se-
lect the {System Operation Check Mode} and press
the [YES] key.
11) On the «System Operation Check Mode» dis-
play screen, select the {Actuator ON/OFF Opera-
tion} and press the [YES] key.
12) Select the desired actuator on the «Actuator
ON/OFF Operation» display screen and press the
[YES] key.
13) Pressing the [NO] key completes the compul-
sory valve operation check mode. The display will
then return to the «Actuator ON/OFF Operation»
screen.
ENGINE (DIAGNOSTICS)
EN-02533
(A)
EN-00040