Subaru Legacy 2002 Service Manual page 1055

Mechanical
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
4) Remove lifting device and wire ropes.
5) Remove garage jack.
6) Install pitching stopper.
Tightening torque:
T1: 49 N·m (5.0 kgf-m, 36.2 ft-lb)
T2: 57 N·m (5.8 kgf-m, 42 ft-lb)
7) Remove ST from torque converter clutch case.
NOTE:
Be careful not to drop the ST into the torque con-
verter clutch case when removing ST.
ST 498277200 STOPPER SET
8) Install starter.
INSTALLATION, Starter.>
9) Install torque converter clutch onto drive plate.
(1) Tighten bolts which hold torque converter
clutch to drive plate.
(2) Tighten other bolts while rotating the engine
by using ST.
ENGINE ASSEMBLY
B3M2045
B2M4024
B2M4323A
<Ref. to SC(H6)-6,
ME(H6)-34
CAUTION:
Be careful not to drop bolts into torque con-
verter clutch housing.
ST 499977100 CRANK PULLEY WRENCH
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
(3) Clog plug (A) onto service hole.
10) Install power steering pump on bracket.
(1) Install power steering tank on bracket.
B2M4322A
B2M3153